Відео

my guy thank you ,i like friends with imagination

Blown head gasket between cylinders.

Cool❤❤❤❤❤

Sounds shit mate

Спасибо

Leaky valves

Looks like a Chevy s10 the way the timing is on the block only

thanks man! but how to fix? which part can i change?

Dude your under the car without stands incase your jack falls

can i install this without removing motor?

Which car did this old belt go to? Mine is unfortunately way too long.

Thank you

Next time make belt loop to the alternator...always works,and you can retorque as well.

First and MOST IMPORTANT…Did you tune the car ?

Subaru issues 😂

You didn't have the belt on the bolt all the way m of course it broke.

Subaru😂 wrong taktikal...

Dry ice works wonders

Would you expecting something different a sign of the insanity

How much does this cost?

What the hell are you doing ?

The easiest way to avoid this pain - DONT BUY FORD VEHICLES PERIOD!!!

My 2jz I put a breaker bar on the bolt and against the ground take out ignition fuse and crank her over

My son and I just did this on a 2013 Santa Fe- tedious, but we got it done and saved a LOT of money. This is a good time to replace the PCV valve as you will have easy access, it may help with unexplained high oil consumption.

What was the auction price through the door?

On a small car yippee! Normal size truck 👎

tywm

It's a Subaru, lay the breaker bar against the frame on driver side and bump the key

Jeremys Subaru of Ft. Levittown would not do this

lol wtf...

Try Left Hand Thread...

Shorten the torques bit so there’s no twist and loose the flex head use a breaker

Have same code on my 17 F150. Do you have to do any programming after replacing the wiper motor? Mine wipers only work on high. Swapped the switch selector on the steering wheel and nothing changed. Preciate it any advice you can share.

I just key bump, it works well. Not evert car is going to have somewhere to do that with a belt

Does the battery hold charge?Does you're engine turn freely with hand?if no it can be from your crankshaft bearings,piston/rings and your head cams components,if yes and the starter still in good condition,check compression for any mechanical condition on all component in the combustion chamber.

Whats with the multiple screen crap... don't pull that artsy fartsy crap on educational clip!!!!

What tools are all needed? For this process my moms 2014 crv water pump is going out

Harbor freight at its finest😂

Blessssss

You're....You're not trying to break the harmonic balancer loose, are you?

That's r e t a r de d audi 3.2

Should’ve left the bolt in at the top so it did shred. That belt looked like shit anyway tho.

Pare un lichid de racire foarte vechi. Pentru cei care nu si-au dat seama ca este busonul de golire al radiatorului.

I have a 2019 and Ford is showing 2 part numbers, one is nearly double the price of the other.

My snap on ones have done the same ,had two go one a hex one a Torx both on a Sunday of all days , Guess what ones didn’t break, for £10.00 got a full set from Halfords not 1 about twenty , and now I use them as first choice, same with the ratchets always needing repair kits had facom ones for ages never use the snap a lot for a while now,

Pre loosened...

Secret way the hard way!!

Thank you❤

I’m in the middle of doing the secondary air valve on my ‘09 WRX, it is a nightmare of a job, and I’ve been repairing cars for over 10 years. Absolutely awful job

Poor Quality Allen !